Safety Blo-Gun w/ 10 In Extension

Safety Blo-Gun w/ 10" Extension

Classified by UNDERWRITERS LABORATORIES to comply with safety & health standards of Walsh-Healy act sections 50-204.8 nozzle pressure, and 50.204 noise level to comply with Williams-Steiger occupational safety and health act "OSHA" section 1910.95 noise level and 1910.242 (b) nozzle pressure. (With maximum inlet pressure of 150 PSI)

This Blo-Gun has a specially engineered internal design to allow a maximum restricted discharge of 30 PSI. Approved by-pass safety nozzle.

Four safety by-pass holes allow air to escape if tip-hole is blocked. By-pass holes do not interfere with normal air flow. Special internal design permits a restricted maximum discharge of 30 PSI. Discharges same air volume as full flow blo-guns, while maintaining required noise level and nozzle pressure. Bent to a special angle to clean out blind holes and offer convenient use on long reach applications.

• Maximum inlet pressure: 150 PSI
• SCFM 5.5 @ 100 PSI
• 1/4" NPT air inlet, nozzle thread 1/2"-27
• Zinc alloy body
• OSHA compliant.