Kent-Moore EN-48869 Front Crankshaft Seal Install

Kent-Moore EN-48869  Front Crankshaft Seal Install

For GM / General Motors. Current SI lists J-35468, but the pilot OD is approximately 3mm too large, and damages the seal. EN-48869 can be used to install the front seal with the engine in-vehicle or out. EN-48869 includes a threaded rod, nut, and thrust bearing to allow service in-vehicle, but is thick enough on the end to allow the seal to be driven into the bore with a dead-blow mallet. Other methods will damage the seal, resulting in premature seal failure.

Usually In Stock
Usually ships in 24-48 hours
Manufacturer Direct

$116.01

This product was added to our catalog on Thursday 27 April, 2017.

Subscribe to our newsletter in order not to miss new arrivals, promotions, and discounts of our store

Thank you for subscribing!

Follow us on social media